We wanted to give you a few basic tips on how to winterize your vinyl liner inground swimming pool. Please note that this is generic information, not intended as a complete winterizing guide. Every pool is different so please be sure to follow specific instructions in your owner’s manual. If you have any questions pertaining to how to winterize your swimming pool, or other equipment, the company you purchased from should be more than happy to help.
Pool winterizing resources are available in several parts. This second installment deals mainly with the area around the pump and filter.
1. Remove all drain plugs from the pool equipment. Do not reinstall your drain plugs until spring. This includes your pump, filter, heater, chlorinator, and any other equipment within the plumbing system. Consult your owner’s manuals for their locations. Lubricate all plugs and o-rings with o-ring lubrican
2. Open the strainer basket cover. Clean the basket and replace. Put your drain plugs and o-rings in the basket. Lubricate the o-ring on your strainer housing with o-ring lubricant and replace the lid.
3. Once all of your equipment has been properly winterized according to the manufacturer’s specifications, make sure all plumbing lines are appropriately winterized based on the requirements of your geographic location.
1. Place the multi-port valve in a neutral position for the winter. This is either between any two grooves, or the “winterize” position if one is indicated on your multi-port valve.
2. If you have a Nature2 Express, remove the cartridge.
3. If you have an automatic chlorinator, drain it, remove the tablets (be sure to follow the manufacturer’s instructions for safe chemical handling), thoroughly rinse with fresh water and replace the lid, but leave it loose enough to allow any gases to escape.
4. If you have a salt water pool, disconnect the cell part of the salt system, unplug it from the power center and bring it indoors for the winter. Make sure to follow the manufacturer’s directions on cleaning it for the winter.
5. If you have an automatic cleaner that uses hoses to attach to your skimmer (such as a Baracuda), take all of the hoses apart and store them straight. Do not coil hoses or they will not work next spring.
• Filters, pumps and heaters can take up to 30 days to completely drain. Do not wait until freezing weather is predicted to drain your filter, pump and heater. If you wait, it will be too late.
• Winterizing procedures on pumps, filters and heaters vary. Always refer to owner’s manual for your particular make and model.
• Some pumps, filters and heaters may have more plugs and drain valves. See your owner’s manual for complete details.
Every area of the country is different and may require additional steps and precautions.